None 33624 Guida di Installazione Scaricare il pdf (Pagina 2)

To give a professional look to trim

installation, drill pilot nail holes straight through the beveled trim edge with a bit slightly smaller than your finishing

nail. This helps to avoid splitting the oak. When the pilot holes are drilled, squeeze a bead of wood glue on each face

of the back side (Figure 3).

Lay the trim in place and drive in finishing nails through the pilot holes (Figure 4). With a nail punch, counter sink

finishing nails. Fill the countersunk nail holes with wood

filler. Consult wood filler label directions for use and drying times.

When filler is dry, use a fine grade sandpaper to sand the trim in the same direction as the grain until the wood is

smooth. Using a flat sanding block helps to keep joints sharp and square. When finished sanding, wipe the trim and

surrounding areas with a tack cloth to remove dust.

1 2 3

Nessun commento

None 33624 Guida di Installazione Pagina 2